Read the two voltage columns
The MIG-205DS Pro lists a lower output range on 110V and a higher range on 220V. The circuit requirement follows the selected side, not the largest model number on the case.
Record the input voltage, rated input current, recommended breaker and plug before using the machine. A licensed electrician must verify the panel and install any new circuit.
Match the accessory to the process
Gas MIG needs a regulator, cylinder and suitable wire. Lift TIG needs a torch, tungsten, gas and filler. Aluminum MIG needs a compatible spool-gun setup.
Unplug the machine before changing polarity, drive rolls or consumables. Confirm the selected bundle actually contains the torch and gas hardware.
Control fume and the work area
Open the garage and place local exhaust near the arc. Keep the machine, cable, gas cylinder and workpiece on a stable setup with clear access to the power disconnect.
Stop if anyone develops dizziness, nausea, eye or throat irritation or breathing difficulty. Leave the area, get fresh air and seek medical advice as needed.